iZone 110 Kit

$259.88

C100K

SKU: VDZIC100K Category:

    Description

    The iZone 110 Kit is a basic low-cost zone only control system which is suitable for switching zones Open and Closed.

    A summary of the features iZone 110 offers are listed below:

    –          Compatible with all leading air conditioning brands

    –          Up to 6 zones available

    –          Add up to 2 wall controllers

    –          Label zone names from a standard library of names

    –          Open zones are identified with a blue LED

    –          Up two zones can be configured as electronic constants.

    There is no facility to control the zones via WiFi or automatically via temperature sensors. The iZone 110 does not interface with the air conditioning unit and the installation will require a separate controller for the air conditioning unit. Furthermore iZone 110 does not incorporate airflow control so balancing dampers should be included in the design.

    It is not possible to upgrade an iZone 110 system to the iZone 400 series however you will be able to use the iZone damper motors, zone cables, transformer and CAT 5E cables.

     

    General installation instructions

    1. The C110MC can be installed on top of the indoor fan coil unit.
    2. Do not run the blue network cables alongside 240 Volt wiring.
    3. When installing network cables down wall cavities or chasing network cables into walls, tape up and protect the RJ45 connector to avoid damage to the connectors.
    4. Always install zones in consecutive ports starting at Zone 1. The back of the C110MC is marked with the zone port numbers.
    5. Do not directly hardwire the CT24ACE into the AC unit’s power supply. This may void the warranty as it will require an electrician in the event that repair of the iZone 110 system is required.
    6. Connect Zone Damper Actuators (CZDA) to the zone ports using the RJ12 cables as shown.
    7. Connect the Wall controller(s) (C110WC) to the C110WC ports using the RJ45 cables.
    8. Only connect the power supply to the CT24AC port after all components have been connected.
    9. Initialise the system.
    10. Configure the system.